Want this question answered?
not sure about all years, but they do not in the 1999.
on the back of the engine where the plug wires plug into the coil it is under the coils i had to remove the coils to get to it hard but can be done
Remove the belt from your 1999 Chevy Malibu alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.
how to remove back brakes on a 2002 Chevy surban
I don't know in the 1999 is the same as 1994 or not. But on 1994 the speaker covers cannot be removed from the felt deck. You need to remove this assembly. It has been awhile since I did this but you basically need to remove the rear light attached to the back window and the back seats in order to get access to the back deck/speaker covers. You may also be required to remove the supports which extend from the back seat up to the ceiling (I don't recall exactly).
Remove the wiring harness from the back of your 1999 Chevy Astro headlamp. Remove the headlamp retaining bolts. The headlamp will come out. Reverse the process to install the new headlamp.
Remove the retaining ring on the top of the cigarette lighter assembly. Pull the cigarette lighter assembly out and remove the wiring harness from the back of the assembly. Reverse the process to install the new cigarette lighter assembly.
the old ones have to be pressed out and new ones pressed back in.
where is fuel shut off on an 2001 Chevy prizm There isn't a fuel shutoff switch on any car. There is a rev limiter to cut back on the fuel at a set rate of speed.jd
Remove the wiring harness from the back of your 1999 Chevy Monte Carlo blower motor. Remove the blower motor retaining bolts. Remove the fan on the front of the blower motor. Reverse the process to install the new blower motor.
If it is the new body style 1999 truck, you will need a 15 and an 18 socket. Slide the seat all the way forward to remove the back bolts, slide the seat all the way back to remove the front bolts , unplug the seat belt sensor and lift the seat out.
2 bolts recline it back and tip it up and slide it out. The only problem is the bolts are big torx heads.