To remove the back seat on a 1989 Ford Thunderbird, the first step is to remove the back of the seat. The back is held in by bolts on each side. After the back is removed, the seat area should come out after removing the floor bolts.
you have to remove the intake manifold it is located in the very back of the engine.fuel injectors and all
Follow the top radiator hose back to the engine. This is where the thermostat is. Remove the 2 bolts and there it is.
you might be able to just go through the back of the glovebox to get to the heater core
where is backup switch located on a 63 thunderbird
at the back of the car
To remove the window in the rear hatch of a 1989 Ford Bronco, the weather stripping around the window will have to be pulled back or pushed down slightly. This can be accomplished with a straight screwdriver or a putty knife.
Remove the inside door panel. The entire window mechanism will be visible. Put the window back onto the window track.
Get in the back seat and grab the rear brake lite and pull the cover toward you. Bulbs are then remove able.
To remove the rear seat from a 1989 Ford Laser 4 door car, first remove the bolts anchoring the rear seat to the floor of the vehicle. Then, lift the bottom portion of the seat from the car. Then, remove the internal bolts from the hatchback or trunk of the car to remove the seat back.
6x8's front and back
The regulator for the 1997 Ford Thunderbird is bolted on the back of the alternator. While the regulator can be changed separately it is more commonly changed along with the alternator.
It is on the back of the alternator, Disconnect the Battery first!. There is a small module on the back of alternator remove and replace.