Want this question answered?
Pull your liner down at the front points of rear bumper and remove the two #10 bolts....take visable bolts and clips off the bottom of cover....lift gate---open storage compartment---remove plastic clips that hold liner and remove liner---remove two black clips that hold trim plate and remove trim plate---there will be 5 #10 bolts inside holes in to remove .....pull cover off! Note: from front points of cover to gate the cover just snaps in.
slide headlinercover back, raise sunroof, unsnapp liner, open sunroof fully, pull the sunroof liner/cover out and tint the the glass or refinish the headlinersunroof cover
You have to have the hood up. Remove plastic liner at the bottom of the windshield by taking out the clips in the rubber liner. The cabin air filter is on the passenger side. Once you have the plastic cover off you should be able to see the filter. I did this using the direction my dealership parts department associate printed out for me.
If you can get to it, remove the wire used to hold the cover on. Remove as much snow as you can, try to minimize the weight on your pool.
you can go in behind the light through the bed liner, or remove the taillight cover
Very carefully, You could try to remove them with a scoop net first. or if the top of the liner is dry vacuum them.
A car is kept slightly cooler when using a hood liner or windshield cover.
There are a number of ways you could remove stains from worms on a vinyl liner. You could use cleaners.
Remove the left front wheel/tire. Remove enough of the plastic clips holding the front part of the wheel well liner so that you can pull it back far enough to access the rear of the headlight assembly. Once you do that you will be able to remove the bulb. Or you can just remove the entire liner, your choice. This is the only way to easily access the low beam headlight.
The easiest way is to partially remove the wheel house liner and stick your hand through there. There should be some push clips that you can remove with a small regular screwdriver. Pull out the center part and then remove the whole push clip. At this point you can pull down on the plastic liner and reach through to the light socket. Small hands work well here.
The battery is in the trunk under the trunk liner, simply remove the trunk liner, remove the hold down and cables and replace...
Unbolt the front of the wheel well liner inside the wheel opening.Remove the bumper cover bolt from the bracket located inside of the bumper at the end.AT the front of the car, remove the bolts holding the bumper cover on, located underneath the vehicle.You should now be able to remove the bumper cover from the front of your Dodge Intrepid.An instructional video has been included to show you the removal process.