answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you remove the blower switch on a 2003 montana?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace the blower fan resistor on a 2003 buick rendezvous?

where is the switch resistor on 2003 buick


How do you replace ther AC blower motor on a 2003 cavalier?

Remove the wiring harness from the back of your 2003 Chevy Cavalier air conditioning blower motor. Remove the air conditioning blower motor retaining bolts. Remove the fan from the front of the blower motor. Reverse the process to install your new air conditioning blower motor.


Where is the blowerheater switch located in the 2003 ford windstar?

it is the switch you use to turn blower up and down.if you mean resistor it is in the heater box next to blower motor


Where is the rear blower relay on a 2003 Tahoe?

Chevrolet Tahoe rear blower relay switch can be found behind the dashboard. The relay switch will be behind the drivers side dashboard.


How do you replace the front blower motor on a 2003 Pontiac Montana?

IT IS UP UNDER THE DASH INSIDE THE VAN ON PASSANGER SIDE 3 BOLTS TO REMOVE IT POPS IN AND POPS OUT AND BE SURE TO CLEAN FILTERS INSIDE THE GLOVE BOX..


Where is the HiLo blower relay switch located on a 2003 Ford Taurus?

behind or below the glove box


How to Remove ignition switch from Nissan?

how to change a ignition switch on a nissan altima 2003


Where is the blower motor in a 2003 Aztec?

it is under the passenger side dash. Very easy to remove.


2003 jeep wrangler heater fan switch works on high only?

Replace the blower motor resistor.


How do you remove a hazard light switch in a 2003 impala?

lollolol


Why won't my heater blower in my 2003 Nissan Sentra turn off?

A bad control switch can cause your 2003 Nissan Sentra heater blower to stay on. The motor or a bad sensor can also cause the heather not to work properly.


Location of 2003 Chevy Silverado Blower Motor Resistor?

you have to remove the glovebox, its behind that, it has 2 bolts and a "connector", should be on the left side of the blower housing.