Lift the bolt, pull it back, and then depress the trigger (just don't make it too "sad" ! ) while pulling it out of the rifle.
The Remington model 700 bolt handle is part of the bolt body and this is a one piece forging.The only way to remove the bolt handle is to cut it off at the bolt body.
codey
Push the safety lever fully forward to dis-engage the bolt stop. Then the bolt can be removed rearward.
Actuate the bolt to the rear and there is a tang in front of the trigger that hangs down..Press up on this tang and pull the bolt back and it will remove it from the action.
You first need to remove the fore arm and then the barrel needs to be removed from the receiver. The bolt will then come out the front of the receiver.
Open the bolt all the way, then push the safety forward and slide the bold out.
There is a button at the beginning of the breach that you pusy in and the bolt will pull straight back out of the breach.
After the bolt carrier is removed, the pin is driven straight down to remove.
Follow the instructions in the owner's manual. If you don't have one, go to Remington's web site and request one.
depress the small square button in front of the trigger when bolt is pulled all th way back
Inside the trigger guard, just in front of the trigger, is a small "button". Depress it, and the bolt can be slid out.
Retract the bolt action to it's furthest open position. Pull the trigger which will release the bolt retaining latch, allowing the bolt to be removed from the rifle.