Want this question answered?
remove the two nuts holding the master cylinder on the power brake booster
The Brake Booster is mounted on the firewall and the master cylinder is mounted on the booster. Look at the booster and you will see a very large vacuum line coming from the booster.
dot 3 brake fluid
No, they are different
Sounds like a Vacuum leak in brake booster.
remove dash trim
remove the silly clip that holds the brake pedal and brake light switch on the pushrod, try not to damage the clip. Remove the four bolts around the brakepedal pushrod hole.(inside, these are tough to get at, a 3\8 air ratchet makes it much easier). remove the two bolts that hold the master cylinder to the booster.Pull the cylinder off booster. do not remove any brake lines, there is enough flex in the lines to get the job done. remove the three hydraulic lines from the booster. You might have to pry a little to get the pushrod off the pedal. remember the wire hanger on the cylinder bolts when you put it back together. Once the pushrod is back on the brake pedal it goes together really easily
Check to see if you have knocked the brake light switch off of its mount. It is located above the brake pedal.
Infiniti I was created in 1996.
Remove the tire and wheel from your 1996 Chevy Cheyenne. Remove the brake spring and the break caliper. The brake pads will come off. Reverse the process to install the new brake pads.
It twists or screws in.
Remove the wheels, pry the drums off.