You need to remove;
Both front Arch liners - 3-5 Grommets not sure exactly how many there are and 2 Torx screws underneath holding them on. (Do this on both sides)
The 2 bolts and 2 clips you see when you open the bonnet (Where the bonnet catch is)
2 bolts underneath holding the under-tray on.
And finally look through the arch gap like where the bumper meets the wing there's 1 bolt on either side undo both of them and your done.
P.S There is nothing else holding it on, may seem like it, just keep wiggling it. this is because the bumper and wing slot together and REMEMBER to put some protection underneath you dont want it smashing off the ground
Hope this helps
Yes
Need to remove bumper
the entire bumper needs to be removed apparently. looking how to remove that would be a good place to start
You First must remove the bumper that should have only nine clips, then remove the right headlight to get to the reservoir. this seems like a lot and it is, but the reservoir is under the headlight assembly and the only way to remove the headlight is to remove the bumper.
you need to remove the bumper to access the 2 10mm bolts of the headlight
You have to remove from bumper and splash gaurd just to change bulb,thats crazy
You must remove the front bumper to access the headlight.
No, you do not need to remove the bumper. here is a video on how to change your headlight really easy. http://youtube.com/watch?v=ieXVCTWQHSY I did it just to see how easy it was and it was pretty easy.
remove laguna bumper
You have to remove the front bumper, remove the headlight assembly. then take the fog light bulb out.
To change the passenger headlight on a Renault Clio, one should open the compartment and remove the rubber seal from the back. From there, the bulb holder should be removed by twisting, then a new bulb should be inserted into the holder.
First, you'll need to remove the front bumper. To do this, take off the bolts underneath the front part of the bumper. Remove the bumper turn signals to access the two bolts per side that hold the bumper on the car. Support the bumper by putting something underneath it. Then get a stubby Phillips screwdriver and remove the two screws per side at the end of the bumper (in the wheel well). Bumper should come off. Remove the headlight assembly by diconnecting the headlight sockets, remove the 10mm bolts above each headlight assembly. Remove the 10mm bolts below the headlight assembly. Done.