answersLogoWhite

0


Best Answer

There are screws going through the bottom into the floor, should be about 6 in the front, middle, and back of the inside of the console.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove the console in a 1998 jeep wrangler in order to remove the carpet?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Remove denim stain from carpet?

Stains from carpet cannot be easily removed with plain water. Stain remover/ carpet cleaner is necessary in order to completely remove it.


How do i remove the upper console in a 2002 sport trac?

To remove the upper console in a 2002 sport track, kindly use your manual so that you get everything in order.


How do you delete nomadix console on your laptop?

In order to delete Nomadix console on your laptop, you will need to go into "add/remove programs". Simply click on the program you'd like to remove and click "remove".


How do you remove the console on a 2002 buick rendezvous?

Remove the cupholder trim pieceDisconnect the electrical connectors.Remove the nuts from the side of the front floor console behind the axxess doors.Remove the nuts from the rear of the front floor console. lower rear corner may have to move seat all the way foward.Lift straight up on the front floor console and pull back in order to remove the console from the vehicle.


What are the wiring connections for the overhead console of a 1999 Dodge Durango?

The 1999 Dodge Durango overhead console wiring connections are beneath the overhead console. You will need to remove the overhead console?æin order to access the wiring connections.


How do you remove the console in a 2001 altima?

In order to remove the console in a 2001 Altima, you have to remove the various screws holding it in place. There are screws on each side and on the outside at an angle with the AC knobs. You will also need to flip the shifter bezel out with a flat?æhead screwdriver to find the rest of the screws.?æ


Why is a carpet given a sudden jerk in order to remove dust from it?

The purpose of giving a sudden jerk is to increase the magnitude of "air friction" (which is used, of course, to remove the dust from carpet) as the friction increases between the carpet and the air the dust is removed very easily but it does spread throught the air.


Where are all the screws on the center air conditioner console on a Plymouth laser I need to remove the console in order to replace the emergency flasher and the air conditioner buttons.?

there's two in between the tach console an air conditioner console under the trim then two under the trim between the tranny console an air conditioner it's easier to take off if you take the tach console off to


How do you take out factory radio in your 06 imprezza wagon?

REMOVAL# Disconnect the ground cable from battery. # Remove the console front panel.# Remove the center panel while disconnecting connector.# Remove the fitting screws, and slightly pull out the audio from center console. # Disconnect the harness connectors and antenna feeder cord. INSTALLATIONInstall in the reverse order of removal.


How do you replace the fuel pump on 1995 VW Jetta?

Remove Trunk Carpet. Remove 3 Phillips bolts holding cover. Remove Clip and Hoses. Unscrew larger ring holding down pump. Remove and Replace in reverse order with new pump.


What could cause a 1991 Mitsubishi eclipse not spark?

I have a 1991 Eclipse GSX and it wasn't getting spark. I tried everything it turned out to be the ECU. It is mounted in the center console of the car. You have to take off the carpet in order to access it.


What is the firing order for a 1994 Jeep Wrangler?

153624