USE special wrenches.
No, but you have to remove the wheel assembly and transmission.
NO, the clutch for the starter is internal. The clutch is on the gear that engages the starter gear.You have to remove left side engine case and remove flywheel to access starter clutch assembly.
http://wiki.answers.com/Q/How_do_you_remove_the_engine_cooling_fan_assembly_from_a_2000_dodge_intrepid"
how to remove a clutch pedal assembly 2004 gmc sierra
I'm in the process right now. Comes out easy if the foot peg was not in the way. I will have to remove engine mounts to tilt engine to remove.
A picture of the clutch assembly removal process for a 250 Polaris Trailblazer can be found in the repair manual. It details how to access, disassemble, and remove the assembly.
To replace the clutch, the engine and transmission must be separated. Some prefer to remove the engine, some prefer to remove the transmission, some remove the entire assembly and separate the engine and transmission once they are out of the vehicle. After the engine and transmission are separated, remove the pressure plate clutch and flywheel, have the flywheel resurfaced by a qualified machine shop. Replace the pilot bearing, clutch disk and pressure plate and use an alignment tool to make certain that the clutch disk is aligned between the flywheel and pressure plate. Then reassemble everything.
In some Nissan Pickups of that year, the fan clutch is actually integrated with the water pump as an assembly. Therefore, the fan clutch cannot be separated from the water pump. There are six bolts holding the water pump to the engine block; remove those bolts and the water pump/fan clutch assembly should come out as a unit.
Four bolts hold it on the clutch if it has one and 4 bolts hold it on front of water pump. Just remove them.
Lefty loosey to remove the fan clutch but the fan assembly rotates CCW when the engine is running.
To change the clutch you need to remove the engine, the transmission or both. The clutch is BEWEEN the engine and transmission and you can't get it off without separating them.
36 mm wrench and a spanner to hold the pulley. Turn counter clockwise to loosen.