answersLogoWhite

0

To remove the clutch from a 2007 Hyundai Tiburon, first, disconnect the battery and lift the vehicle to access the transmission. Remove the transmission by unbolting it from the engine and separating it from the clutch assembly. Once the transmission is out, unbolt the pressure plate from the flywheel and take out the old clutch disc. Ensure to clean the flywheel surface before installing the new clutch.

User Avatar

AnswerBot

2mo ago

What else can I help you with?

Related Questions

Is a 2007 Hyundai Tiburon window motor compatible with a 2003 tiburon?

no but its is with the 2005 -2007


Can you get a 2007 Hyundai tiburon awd?

No, they are FWD


How many RPM should the engine turn at 80 kph in 2007 Hyundai tiburon?

How many rpm should the engine turn at 80 Mph 2007 Hyundai tiburon


What size speakers are in a 2007 Hyundai Tiburon?

Try to use the Hyundai Tiburon speaker adapters plugs so you don't need to cut wires and mess up the electric system, you can get those from eBay or amazon.


What is the average monthly cost for a 2007 Hyundai tiburon?

What did you pay for the car??... you can times that by 2..thats, X2


What octane should be used for a 2007 4spd automatic Hyundai Tiburon?

87 or higher but the manual says 91


Where is crankshaft sensor located on 2007 Hyundai tiburon?

crankshaft? what crankshaft? I think thats the engine connector you're pulling


Hyundai tiburon 2007 oil type?

V4 = 4.2 quarts 5w-30 V6 = 4.5 quarts 52-30


Where is the idle speed control in a 2007 tiburon located?

In a 2007 Hyundai Tiburon, the idle speed control is integrated into the throttle body assembly. It typically consists of an idle air control valve (IACV) that regulates the amount of air entering the engine at idle. To access it, you would need to remove the air intake duct and possibly other components to reach the throttle body.


How do you remove the flywheel from a 2007 3500 dodge after the clutch and clutch dics have been removed?

The flywheel just bolts up, remove the bolt.


What is the wheel bolt pattern for a 2007 Hyundai Tiburon?

The wheel bolt pattern for a 2007 Hyundai Tiburon is 5 bolts with a spacing of 114.3 mm (4.5 inches) and a thread size of M12x1.5. This means the distance between the centers of two adjacent bolt holes is 114.3 mm. Always verify with the vehicle's manual or manufacturer for accuracy before making any changes.


What type of oil do you put in a 2007 Hyundai Tiburon?

For a 2007 Hyundai Tiburon, it is recommended to use 5W-20 or 5W-30 synthetic motor oil. Always check the owner's manual for the manufacturer's specifications and recommendations. Additionally, ensure that the oil meets the API certification standards for optimal performance. Regularly changing the oil as per the recommended interval is also essential for engine health.