http://wiki.answers.com/Q/How_do_you_remove_the_engine_cooling_fan_assembly_from_a_2000_dodge_intrepid"
USE special wrenches.
Remove the lower radiator hose or loosen the radiator drain.
1.Remove the radiator and cooling fans as a single assembly 2.Remove the bolts and separate the fan/shroud assembly from the radiator 3.Remove the clip and detach the fan blade assembly from the motor shaft 4.Remove the screws and detach the fan motor from the shroud
Engine cooling system is not a closed system you can't remove the air.
To remove the engine cooling fan from a 2003 Saturn Ion, first disconnect the negative battery cable to ensure safety. Next, remove the front grille and the radiator shroud to access the fan assembly. Disconnect the electrical connector from the fan, then unbolt the fan from its mounting points and carefully pull it out from the engine compartment. Finally, reverse the steps to install a new fan if needed.
Behind and below the passenger side headlight assembly. You also must remove the air filter to get to the battery; it also helps to remove the front wheel well to make it easier to get to the battery. It a pain to get to on the Intrepid but it's possible.
Engine cooling system is not a closed system you can't remove the air.
Must remove the entire engine
in the trunk there are 3 plastic wing nuts take them off and the light will come out.
You just have to pull back the trim in the trunk to access the fasteners for the taillight assembly. Once you remove the taillight assembly just replace the bulb.
The engine and trans are removed as an assembly out of the bottom.
The engine and transmission are removed out the bottom as an assembly.