' Disable the timer tmrMyTimer.Enabled = False ' in milliseconds, you can remove this line if you do not want to change the ' internval from the original setting tmrMyTimer.Interval = NewInterval ' Enable the timer again tmrMyTimer.Enabled = True
On the passenger side-Under the ECU cover.. On he
CAUTION: Some models are equipped with anti-theft-radio make sure you have the activation code before disconnecting battery * Disconnect negative battery cable * Detach the accelerator cable from the cable guides on the valve cover (It's not necessary to remove the cable guides unless you're replacing the valve cover) * Disconnect the PCV and breather hoses from the valve cover * Remove the spark plug wire cover bolts remove the cover and then remove the spark plug wires * Remove the bolts that attach the upper timing belt cover to the valve cover * Remove the valve cover bolts and then remove the valve cover
by sliding the cover of timer upwards until it close your e950 keypad will not be unlocked..........................
remove right valve cover on cadilac sts
Remove the valve cover
How to remove drivers' side light cover
No
pull the wheel, remove the bearing dust cover, remove the cotter pin, remove the castle nut, slide the hub off, take out the rear seal and bearing, knock out the races reinstall in reverse order. pack bearings and hub with good grease don't go cheap. oh it helps to remove the brake caliper for a first timer
Remove the screws in the wheel wells and underneath the plastic cover to remove the bumper cover. Then you can see to remove the actual bumper.
pull of plug wires and the 2 vacum hoses on the valve cover remove the accel cable and cruise cables and bracket also remove bracket by alt, remove 2 bolts in front of timing cover holding wiring on top of valve cover from alt, remove big nuts on top of valve cover there is 4 remove spark plug hole seals.remove cover....reverse to install
You are probably not going to remove the "stain" from the cover. It has been bleached of all pigment.