Want this question answered?
Attached to the transaxle housing,look for the cone shaped axle hub a large wiring harness is also nearby
It is on the front of the crankshaft, under the timing chain housing.It is on the front of the crankshaft, under the timing chain housing.
The crankshaft sensor mounts through the top rear of the transmission bell housing.
There are two of them, and they are located on the clutch bell housing that is bolted to the rear of the motor. They are held down with 10mm bolts that can be accessed if you stand on the drivers side of the engine bay and feed an extension with a swivel down past the wiring on the firewall.
The crankshaft sensor is located directly above the oil filter housing by the alternator.
behind engine , on top of transmission housing , slightly to the right side.There is some 30cm of cable attached to sensor and than a connector to instalation.
It is under the housing where the rad cap is attached.It is under the housing where the rad cap is attached.
The crankshaft position sensor mounts to the top rear of the transmission bell housing.
trany bell housing
left bank of motor on the bell housing
The upper radiator hose is attached to the thermostat housing.
The crankshaft position sensor is on the driver side top of the transmission bell housing.