answersLogoWhite

0

Wash it once in a while.

Darkened, rough patches on your elbows are usually a sign of layers of dead skin with ground-in dirt. You can get pumice stones to use to buff them away, but generally just washing is enough for most people.
User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

How do you remove elbow hose from water pump to block on 2005 impala ss?

remove the belt and the housing, the elbow then pulls out, only the rubber seals hold it in


How do you remove antifreeze stain from glass?

Elbow grease


How do you remove ink from wooden table?

You have to rub it with toothpaste from your elbow. trust me without rubbing it with your elbow it doesn't work


How do you remove electroplating?

Use fine sandpaper and elbow grease.


How do you remove a difficult bolt?

WD40 and some elbow grease


Where is the thermostat on a 93 Saturn?

THE THERMOSTAT WAS NEAR THE LOWER HOSE OF THE RADIATOR .WHERE THE LOWER HOSE CONECT THERE IS A LITTLE ELBOW WHIT TWO 10 MM BOLT REMOVE THE ELBOW AND FOLLOW THE INSTRUCTION OF THE NEW THERMOSTAT . REMOVE THE COOLANT BEFORE BY THE PLUG JUST UNDER THE ELBOW


How much does it cost to remove bursa sac in elbow via surgery?

$20,000


How do you remove wooden finishes?

with a big chissel and some elbow grease :) x


How do you remove the glove box on 2001 jetta?

With a hammer/crowbar and some elbow grease


How can you remove pine sap that has dripped onto your car?

WD-40 and elbow grease.


What is the best way to clean and maintain a dishwasher elbow to ensure optimal performance?

The best way to clean and maintain a dishwasher elbow for optimal performance is to regularly remove and clean it with a mixture of vinegar and water to remove any buildup or debris. Additionally, running a dishwasher cleaning cycle with a specialized cleaner can help keep the elbow clear and functioning properly.


Whatisthe best way to remove thermostatin 1977 Cutlass Supreme there is an elbow pipe holding it in place?

That elbow pipe ( thermostat housing ) has 2 bolts in it, take them out and remove the housing ( you may have to tap it with a rubber mallet) be sure to have a new gasket ready and remove all traces of the old one before reassembly.