If you want to totally remove the panel, you will need to remove the door handle latches between the panel and the door. There are two metal "arms" with white plastic connectors on the ends. One arm goes to the door handle on the outside of the door and one goes to the handle on the inside of the door. This was rather difficult since it was hard to get your hands in there. Good luck.
Also If your car has manual windows their is a small spring clip holding the window crank on. You can remove the clip easily by using a 90 degree pick to hook the clip and pop it off. When you are reinstalling the window crank put the clip on the crank first and simply pop the handle back on.
ive placed the on the same question on the 97 model same gos for all of the above models
http://neons.org/howtos/door/
(Manual windows)If I'm not mistaken, the 2000 model of the Neon is mostly the same in the door model from 95 till, well now. What you need to do, is take out the small door close handle(inset) with a Philips screw driver (The screw is in the very center of the inset door close handle). Then you want to push the door inward toward the outside of the car around the roller for the window and remove the Jesus clip(make sure and keep the Jesus clip lying somewhere safely because without it, you will not be able to re-assemble the roller and have it stay) and then you should be able to safely pull off the door cover.
(Power Windows)Remove the door close handle(inset) and the whole door cover should come right off with a few tugs in certain spots.(The door is held on by a few snap tight pieces of plastic around the outer edges of the door. Be careful not to tug it off too hard for fear of damaging your power wires to the power window motors. Once you have the door off a few inches, you should be able to unplug the main harness to the power window motor and be able to remove the door cover completely and lay it safely to the side.
http://neons.org/howtos/door/
how to remove a door lock cylinder on 2000 dodge neon
Unless there is an access panel above the fuel pump, you must remove the fuel tank.
Yes.
no a 2001 dodge neon motor will not work in a 2000 neon
The 2000 Dodge Neon computer is behind the kick plate on the passenger side of the passenger compartment. Remove the kick plate. Remove the computer retaining bolts. Remove the computer wiring harness.
Haynes repair manual, Dodge Neon 2000 thru 2003. Book #30036
Yes, there is a legend to the fuse panel of a 2001 Dodge Neon. It is found on the fuse panel cover, and in the owners manual.
Where is the oil sending unit on a 2000 dodge neon?
A 2000 Dodge Neon does not have a maf sensor.
Haynes repair manual, Dodge Neon 2000 thru 2003. Book #30036
Click on the link to your right for instructions.
remove the top trim panel off the dashboard, the front trim panel from the instrument panel and remove the screws. good luck finding a replacement cluster