For the front doors, remove the inner door skins (grab the bottom and pull gently.) You can probably get away with just pulling the bottom loose enough to reach the screws around the speaker box. There are 3 or 4 screws holding the speaker box in. Remove the screws and unhook the old speaker. Pull the box out from under the door skin. There are 4 nuts holding the speaker to the inside of the box. Remove those (it's tight so you may want to use a needle nose pliers.) and the speaker is free. The rear speakers are a little easier. The box is contained in the armrest. This is held on by a couple of screws on the bottom. Remove these screws and lift the arm rest free. The speaker is contained in a box similar to the front.
Try using tools...if that doesn't work, crowbar
If its a convertable, remove the the screws under the rear seat and remove. Then remove the screws holding the leather enclosures and remove from sill plate. remove the speaker boxes and replace. If you don't have new speaker boxes remove cover a speaker box, access speaker and replace, you will probably have to solder the wires, then reverse the order and put back together.
Remove door panel, remove 4 screws, remove speaker, put new speaker in, replace screws, replace door panel. Done.
How do you replace thermostat housing in 1999 Jaguar XK8? Can't seem to remove bolts without having to remove value covers. Help
how do you remove and replace rear bumper on an xtype jag
rear door-remove the door panel. back speaker carefully pry off grille cover and replace speaker
# Remove the door trim panel # Remove the mounting screws withdraw the speaker unplug the electrical connector and remove the speaker
You remove four screws with a small L key and then carefully remove the top plastic from the speaker ......then remove the speaker from the lower plastic.....Its a bit tuff but it can be done and then replace speaker.....you also need to remove the receiving part from old speaker and use it to connect you new one. or you can cut off the plug and connect speaker direct and tape it
if it is a series III - remove two screws at the bottom of the armrest. pull out ash tray. remove screw in the middle of the ash tray holder. pull up on armrest, it should pop up, then pull it out start at bottom right of door and start popping out the plastic clips (all the way around the door) (remove speaker wires) push up door panel - DONE
Remove the door trim panelRemove the speaker mounting screwsPull out the speaker,disconnect the electrical connector from the speaker and remove the speakerInstallation is reverse of removal
Yes, the Speaker is in the door.
Remove the door speaker cover. The cover is held in place with two retaining screws. Remove the speaker retaining screws. Remove the wiring harness from the back of the speaker. Reverse the process to install the new speaker.