answersLogoWhite

0


Best Answer

I have a similar problem for a 2002 Chevy Malibu. I can tell you the window rocker switch comes out with two clips on the window up and down ends just put a small flathead screwdriver in-between. The small panel right by the review mirrors just pops off also no screws. And there is another small panel right behind the handle the hides two screws. That

User Avatar

Wiki User

โˆ™ 2006-08-14 17:48:52
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove the door panels to access the electric window parts on a 2000 Chevy Malibu?
Write your answer...
Submit
Sign up for more answers

Registered users can ask questions, leave comments, and earn points for submitting new answers.

Already have an account? Log in

Related questions

Is there a fuel pump access panel on a 2001 Dodge Intrepid?

No, you will have to remove the tank.The 1993-1997 Intrepids where the only ones with access panels.No, you will have to remove the tank.The 1993-1997 Intrepids where the only ones with access panels.


How do you remove the door panels to install door speakers on a 2001 Chevy Malibu without electric windows?

There is a clip on the back side of the window crank that you have to take off, then take the door panel off.


Can you remove the fuel pump on a 2007 Chevrolet Malibu through the back seat?

If there is an access panel, yes. If not you will have to remove the tank.


How do you change a taillight bulb in a 2001 Hyundai Elantra?

Inside the trunk or hatch on each side there are plastic access panels. Remove these panels to get access to the sockets which are twist locked into the reflector housing.


How do you I replace rear speakers in a 99 mercury villager?

You will need to remove the inner panels to gain access.


How do you remove door panels to access speakers on a 2000 Chevy Malibu?

You must remove those pieces that don't seem to flow with the door panel (they pop right off with a screw driver), then you will se screws underneath them... unscrew these screws and the door panel should easily pop right off.


How do you access rear shocks on ford escape 2005?

The upper nut for the shock is behind the quarter panels at the very rear or the vehicle. There is an online guide on how to remove the panels.


Do you have to remove the gas tank on a 2004 range rover to access fuel pump?

No. There are two round access panels located under the rear seats.


How do you get access to the low beam headlight bulb on a 2000 Chevy Malibu?

Remove the entire head lamp assembly


How do you remove the interior door panels on a 1996 Honda Prelude?

Need to know how to remove the interior door panel so I can replace motor for electric window


Where is the fuel pump located on a 02 v6 Chevy Malibu and how to replace one?

Located in the fuel tank -have to remove for access


How do you replace a headlight bulb on a 2008 Malibu?

Remove tire & inner liner to gain access to head light assembly


How do you remove the tail light in a rav4?

remove the 2 side panels to access the mistery screws. there are 4 or 3 screws on each light. a pain in the bt


How do you install a fuel pump on 300zx?

On z31 its located in the gas tank, you need to remove the tank. Z32, you don't have to remove the tank but you have to remove the panels in the trunk to access it from the top of the tank.


How to remove the 2004 civic door panels?

in the door opener there is a cover, remove it to access the 2 Philips screws, then unclip the cover of the door andle to access the 2 Philips screws. grab the panel by the botom then unclip it


Where is the accumulator on a 2000 Malibu?

Behind right front fender behind headlight. Access from under neath. Remove plastic shield, and there it is.


Where is the horn located on a 99 Chevy Malibu?

the horns are located on the passenger side under headlight in the fender. remove the plastic panel to access them. you may have to remove wheel also.


How do you take off dash in 2006 Chevy Malibu?

To take off the das in 2006 Chevy Malibu you need to take both the IP and end panels off by unclipping them on place. After that, remove the 7mm bolts that hold the driver knee bolster in place.


How does one remove access panels from an electrical junction box?

Removal of an access panels from an electrical junction box depends on the type of junction box in question. Regardless of type, the first step in the removal should be the cutting off of the power main to the box itself.


Do you have to remove the light housing assembly from the body to get access to the tail lights on a 1997 Mitsubishi 3000 GT?

Yes, there are about 6 bolts on each side you have to remove, you do not have to remove the molding, just use the access panels, however you have to pull the center part out, (3000GT part) a bit to remove the tail light.


Where is the ECM located in a 1992 Eagle Talon?

It's located under the center console below the radio. Remove the side panels to access it.


How do you remove the factory speakers on a 1996 Pontiac sunfire?

One in each door have to remove door panels for access & 2 0n deck lid in trunk get acces to trunk for these speskers.


How do you remove a water pump on a 2005 Chevy Malibu 2.2 ecotec?

how do I remove a watwr pump on a 2005 chevy malibu


Where is the crank position sensor for 1997 Chevy Malibu?

The 1997 Chevy Malibu crankshaft position sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft position sensor.


Where is the horn on 1996 Malibu?

I wasn't aware there is a 1996 model of Malibu, but on my 1998, the horn is behind the passenger side front fender, between the bumper and wheel. To access it, you must remove the entire front bumper cover.