You will need to remove the inner panels to gain access.
Remove the covers to your 2000 Chevy Malibu rear speakers. Remove the speaker retaining screws. Remove the wiring harness from the back of the speakers. Reverse the process to install your new rear speakers.
Remove the door panels and unscrew the grills, then unscrew the speakers
To access the speakers on a 2000 Malibu, you will need to remove the door panel. You also may need tools like screwdrivers and a wire cutter to take the door panel off. Before starting any removal of the panel, you should disconnect the negative battery cable.
Remove the dash pad, then remove the speakers from the dash frame. For the rear speakers, open the trunk and remove the brackets, that hold the speakers in place. not for the back speakers ..you have to remove the lower rear seat then remove the seat belts then the rear seat back then remove the header panels in the back seat then remove the deck cover ..the rear speakers are bolted in from the top down under the rear deck cover....and the front speakers i believe are mounted in the door panels in the front doors ..you have to remove the door panels to remove them .some do have them in the dash also if they are there u do as the person stated before me.
If your talking about the door speakers then you will have to remove the door panels to get to the speakers.
Remove door panels.. Unscrew old speakers..Screw in new speakers..replace door panels...ready 2 GO..
1.- remove the doors panels 2.- remove the old factory speakers
One in each door have to remove door panels for access & 2 0n deck lid in trunk get acces to trunk for these speskers.
No, you will have to remove the tank.The 1993-1997 Intrepids where the only ones with access panels.No, you will have to remove the tank.The 1993-1997 Intrepids where the only ones with access panels.
There is a clip on the back side of the window crank that you have to take off, then take the door panel off.
To replace the front speakers in a Toyota Sienna the door panels must first be removed. With the door panels removed the speakers will be easily accessible and the mounting screws can be loosen. Unplug the speakers and remove them. Install the new speakers.
remove the door panels
Remove speaker grill covers on dash to expose tweeters then remove door panels and you will se the rest of speakers
You have to remove the door panels
To change the front speakers, you will have to remove the door panels to expose the speakers. Once exposed, unhook them by disconnecting all the wires.
Remove the floor sill covering, it has 5 or 6 screws, then you can access the speakers.......
the rear speakers are located in the back doors. you have to remove the door panels to get at them.
You don't need to remove front door panels, the speaker grills come out.
Take the door panels off for the front. The back you can pull the grill off covering the speakers for direct access or remove the panel. Fairly easy to do, you will need torx drivers tho. I have the same question
Gentle start on the fabric panel when the speaker cover is located and pull a small portion at a time.
remove a couple screws and carefully lift up and then out with it.
you have to remove the whole door panel in order to gain access to the factory speakers in which should be 4x6.
Remove the door panels and replace the speakers. They sit in baskets and are simple to replace. We have instructions at our enthusiasts forum. www.trailvoy.com
Remove the doghouse (engine cover) and remove the heater duct. Then you can access both speakers through the doghouse.