Want this question answered?
How do you remove and replace the motor for the drivers side power window in a 2000 Sienna
To change the motor in the 1996 Chevy Cavalier driver's side window, first pry the interior door panel from the door. Then, remove the motor by first disconnecting the vehicle's battery and then disconnecting the wiring to the motor. You can then remove the screws that hold the motor in place.
Remove the inside door panel. Remove the window motor track linkage. Remove the wiring harness. Remove the window motor retaining bolts. Reverse the process to install the new window motor.
You have to remove the door panel and anything else like door pulls and window handles.
in the door
Breaking this question into the 2 primary components: how to remove the door panel - and - how to replace the window motor. Both are well covered in the "Related Questions" below
The 1995 Cadillac Eldorado drivers side door panel is held in place by eight retaining clips. Pry outward on each retaining clip. The door panel will come off. Remove the linkage from the power window motor. Remove the wiring harness from the power window motor. Remove the retaining bolts. Reverse the process to install the new power window motor.
remove side pannel on driver side to get to the window on a 2001mustang v6
Replacing 2002 Dodge power window motor driver side
Remove the driver side panel remove loosen the three bolts holding the motor in place, lower the window by hand till you can see the two bolts that hold the window to the raising/lowering mechanism remove the bolts completely, then reach up from bottom and squeeze the bushings out the window sit on a ledge on the raising/lower bar which is entirely plastic... be careful not to force anything or the window will shatter the power window motor and cable should be replaced unless the trouble is just the motor but if the window moves even a little the trouble is likely in the cable system that is part of the motor assembly. Remove the driver side panel remove loosen the three bolts holding the motor in place, lower the window by hand till you can see the two bolts that hold the window to the raising/lowering mechanism remove the bolts completely, then reach up from bottom and squeeze the bushings out the window sit on a ledge on the raising/lower bar which is entirely plastic... be careful not to force anything or the window will shatter the power window motor and cable should be replaced unless the trouble is just the motor but if the window moves even a little the trouble is likely in the cable system that is part of the motor assembly.
Open driver side door. remove inner door panel lower window pull it out of the bracket.
I would check the switches first then check the window motor for passengers side.