Want this question answered?
Remove the grill and the headlights will sort of hinge out so you can pop cover off back.
how to remove the timing cover for a landrover freelander diesel engine
just go to the dealer they have all the codes for your keys no need to remove the lock
Begin by removing the rear engine cover from your 1997 Land Rover Discovery. Remove the crankshaft sensor wiring harness. Remove the crankshaft sensor retaining bolts. Reverse the process to install your new crankshaft sensor.
u just drop the motor by undoing the bolts
take a hammer and hit it right and left.............
Remove trans oil pan ( 6 x 10mm head bolts and clamps). Remove filter by removing 3 x T27 screws (torx head). be careful to replace all O ring seals carefully.
If it is the original 306 up to about p reg before the facelift model then you just remove the wire from the cap and unscrew it with a socket. Easy!! If it is the facelift model then it's protected as part of the immobilizer and is very difficult to remove for obvious reasons. Garage job..
The front fenders on your Land Rover Discovery are held in place with eight retaining bolts. Remove the retaining bolts and the front fender will come off.
Inside the fuel tank. Remove the carpet and the padding from the back cargo area of your Discovery. There will be a round hatch. Remove the cover and the fuel pump will be right there for it's removal.
If you are trying to do this in a pre 2008 (facelift) Mazda6, I purchased my bulbs from: http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=190510970759 and they can help you with a guide to remove it too.
Remove engine cover. Remove plastic cover over injectors. Camshaft sensor is in front of the oil filler cap, 3 wire black connector. It's held in by one E-Torx bolt. Remove the bolt and connector and it pulls straight up.