Ford Taurus
Mercury Sable
Chevy Blazer S-10

How do you remove the front axles from a 1994 Ford Taurus?

888990

Top Answer
User Avatar
Wiki User
2015-07-15 21:41:14
2015-07-15 21:41:14

You can use a large screwdriver placed between the inner bearing race and the transmission to CAREFULLY lever the drive axel out of the transmission.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

On a 1994 Ford Taurus , V6 : firewall 1-----2-----3 4-----5-----6 front of vehicle

User Avatar

firewall 1-----2-----3 4-----5-----6 front of Ford Taurus > driver

User Avatar

The front axles are your "driveshafts" on ALL front wheel drive vehicles. Other wise there are no drive shafts.

User Avatar

Thunderbirds never had a front axle

User Avatar

On a 1994 Ford Taurus : firewall 1-----2-----3 4-----5-----6 front of vehicle > driver

User Avatar

yes, butmay have to change speed sensor if wire connecto is different. axles are same

User Avatar

Complex Job you need to [http://www.themotorbookstore.com/index.html Purchase A Manual]

User Avatar

When you remove the caliper, the pads can be pressed out by hand.

User Avatar

With the wheel off, remove the calipers, then the rotors just come off.

User Avatar

Remove the floor sill covering, it has 5 or 6 screws, then you can access the speakers.......

User Avatar

"http://wiki.answers.com/Q/How_do_you_remove_Front_Rotors_on_a_1994_ford_ranger"

User Avatar

The 3.0 and the 3.8 liter V6 engines in a 1994 Ford Taurus are fuel injected , so there is no carburetor

User Avatar

On a 1994 Ford Taurus : The 3.0 and 3.8 liter V6 engines use a timing CHAIN

User Avatar

remove belts,remove crank pulley,remove seal.you need to check front cover they are bad about timing chain rubing holes through it.

User Avatar

No - way too many changes made to the Taurus between the 2 model years.

User Avatar

In a 1994 Ford Taurus : Both the 3.0 and 3.8 litre V6 engines have a timing CHAIN

User Avatar

Hi, According to Crutchfield.com, they are 6x8 and the front are 6 1/2. Hope this helps. Steve H.

User Avatar

GL= Grand Luxe (Luxury ver of Taurus)

User Avatar

Maybe the information for a 1998 Sable/Taurus in the "Related Question" below will help with your 1994.Should be very similar

User Avatar

Check drivers side fender, near the front. It's by passenger side near the firewall.

User Avatar

wear gloves, bearings all come out. then you have to remove the sensor off the back of it. along with 6 17mm bolts. How do you change the rotors in the front on a 1998 Isuzu Trooper

User Avatar

no,the 96 is electronically controlled,the other trans is not

User Avatar

The price of a fuel filter on a 1994 Ford Taurus

User Avatar

For a 1994 Ford Taurus GL : The base engine was the 3.0 litre " Vulcan " V6 engine The optional engine was the 3.8 litre V6


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.