* Disconnect the negative battery cable * At the bottomof the door panel remove the two screws * Pry up at the front edge of the power window switch pod and lift it out then unplug the electrical connector * Remove the inside door handle escutcheon * Remove the screw in the door pull pocket * Pull the door panel away from the door far enough to disconnect the electrical connectors
Can figure out how to remove rear rotor assembly to replace wheel bearing assembly on a Maxima 2004 Nissan
remove front door panel 1995 Nissan maxima
How do I remove An 87 Nissan maxima gas tank
I need a step-by-step how to change, remove and replace an alternator in an 1996 Nissan maxima
the knock sensor is located under the intake manifold, with a flash light you can see it however you have to remove the intake manifold to replace the knock sensor , also you will need to replace the intake gasket set as well!
Remove engine, disassemble, replace piston, re-assemble engine and install. Good times!
The intake and exhaust manifolds, along with the timing belt will have to be removed to gain access to the head. Remove the head and replace the gasket. Torque the bolts down to the manufacturer specs and in the order Nissan suggests.
what year maxima? please email ttrung1979@yahoo.com In i can tell you how to do it..
You pretty much have to remove the entire heater box under the dash on the passenger side
To change the trunk light in a 2002 Nissan Maxima, a person will need to unscrew the cover over the light. Then they can remove the old bulb and replace with a new one. Then screw the lens cover back on.
* Remove the air intake duct from the throttle body and air filter housing * Detach the vacuum line from the EGR valve.Disconnect the EGR pipe nut * Remove the EGR valve mounting fasteners * Remove the EGR valve and gasket from the manifold.Discard the gasket * With a wire wheel buff the exhaust deposits from the EGR valve mounting surface on the manifold
* Remove the air intake duct from the throttle body and air filter housing * Detach the vacuum line from the EGR valve.Disconnect the EGR pipe nut * Remove the EGR valve mounting fasteners * Remove the EGR valve and gasket from the manifold.Discard the gasket * With a wire wheel buff the exhaust deposits from the EGR valve mounting surface on the manifold