Hit a Large tree or pole
It will be necessary to remove the front license plate and bracket. Remove license plate from bracket. Using a 3/16" drill bit, drill out the two pop rivets that hold the bracket to the bumper. This is from a a bull bar installation guide for a 2008 Ford Escape/2008 Mercury Mariner.
Probably not. That's why you have a bracket in your front bumper.
There is not a front licensing mounting bracket, on a Chrysler Sebring. The Chrysler Sebring has a rear license plate mounting bracket.
The Honda Pilot does not come with pre-drilled holes for a front license plate bracket so first you have to drill the holes. Once the holes are drilled then you can use the screws that came with the bracket to secure it into place.
Buy the bracket from Honda with the hardware. in the front grill you will see two screw holes. Just line it up with the bracket and screw it on.. That simple
I will be replacing one on a 2006 Pilot, and I'm not sure if this will work the same, but it requires you to remove the old hardware (if still attached), clip in the bracket on the front of the bumper, and bolt in the two flat, horizontal attachments underneath the bumper.
Try dealer or E-Bay
Yes, use a bracket.
The answer is yes. The vehicle may not be setup for it because often times auto manufactures do not put the front license plate bracket on. It is generally the responsibility of the dealership to put the front license plate bracket on.
Not all vehicles come from the factory withe the front plate bracket installed. If you don't easily see it, then you will have to buy one from the dealer.
With thh proper license plate bracket and screws.
how to install volvo 740 turn signal lens