To remove the harmonic balancer on a 1990 Nissan 300ZX, first disconnect the battery and remove any accessories obstructing access, such as the fan and belts. Use a harmonic balancer puller to ensure safe removal by threading it into the balancer and turning the center bolt to pull it off the crankshaft. Be cautious to support the engine if necessary, and ensure all bolts are properly torqued during reinstallation. Finally, check for any damaged seals or components before reassembly.
you buy a pulley grabber kit, make sure you get one large enough to fit over the harmonic balance. but be careful not to damage it, harmonic balances are expensive to replace.
You will have to remove the engine.
Ask the dealer, I believe so. Its the same motor from 89 to 96 with minor differences.
No, you will die.
There were 3,000 Nissan 300zx convertibles made
VG30DETT is in the 90-95 Nissan 300zx. It is a v6
Remove the radio and the fuse is behind the radio
first remove the fan and shrould. then the radiater and hoses. next remove the thermostat housing. remove the harmonic balancer(27mm or 1 1/16 shallow socket).remove all timing cover bolts(upper and lower). remove driver's side timing cover and move passenger side cover up just a bit to allow lower cover to be removed. a little tricky on the lower drivers side. may have to remove coolant temp sender and coolant temp sensor on the other pipe. no need to remove timing belt
Yes it will
yes!
no power to starter on Nissan 300zx twin turbo
replace coil springs in a nissan 300zx