0
This is best done with two people, but it is possible for a Strong fit male to do. I would not try this if you are a female as it is heavy and awkward to move the hatch alone and you could easily injure youreself. First take notice of the two small covers on the outside top of the car just above the hatch. Now open the hatch and look to the spot where the small covers join the hatch. Each of these caps is held on by two Phillips head screws. Take these out, then carefully close the hatch but don't let it latch (its not a problem if it dose, but you will need to open it again later). The small caps will slide forward and then you can lift them up and off of the car. Set these aside for later. After you have removed the caps you should have exposed the nuts that are holding on the hatch. Now open the hatch again. At this point you will need two people or an extreemly strong head, neck, and back. With the hatch up, remove the gas struts supporting the hatch. At this point DO NOT LET THE HATCH CLOSE. Put a pice of cardboard over the latch and rest the hatch on it so it will not close. Now remove the nuts holding the hatch onto the car. If memory serves me they are 13mm nuts. After all 4 are removed, position one person on each side of the car. At the same time lift the hatch together and set it aside. Now if you want you can put the small covers back on the same way you took them off. To put the hatch back on just do those steps in reverse.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Do you have to remove the trans when you replace an engine on a 1988 Nissan Pulsar?
no u do not
Where 1988 Nissan Pulsar fuel filter?
i have no clue
Does the 1988 Nissan Pulsar se have two separate front windshield wiper motors?
No
Where can you get a engine wiring harness for a 1988 Nissan Pulsar NX?
The best place is to get it from a wrecking yard.
What is the spark plug gap for a 1988 Nissan Pulsar vector gx 1.8?
The spark plug gap for a 1998 Nissan Pulsar with the 1.8L L4 is .044-inches. The Nissan OE plug for this application is the NGK Laser Platinum part#4045.
How do you put your new Sony stereo in your 1988 Nissan Pulsar?
Take out centre dash, for starters. Remove old unit. then find on the internet the wiring harness diagram to specify what each wire is then match this up with the wires on your sony stereo. hope this helps
Have brake line leaking under the drivers side how to fix?
1988 nissan pulsar leaking brake fluid under drivers side door what is part name
How do you add clutch fluid to a 1988 Nissan Pulsar?
Look near the brake master cylinder for a reservoir or your brake fluid and clutch fluid might share the same reservoir
Where is the water pump located 1988 Nissan Pulsar?
the water pump is usually operated by the cam so have a look around the cam sprocket. you'll have to take the timing cover off.
How do you disarm the antitheft on a 1988 Nissan Maxima?
The easiest way to disarm your antitheft system on your 1988 Nissan Maxima is to remove the fuse. The antitheft system fuse location can be found on the inside cover of the fuse box.
How do you replace the passenger side mirror on a 1988 pulsar?
First remove the leather triangle cover on the inside of the car, where the mirror mounts. there are several screws there, and a electrical connection if you have power mirrors.
What is the bolt pattern for a 1988 Honda civic hatchback dx?
5 x 114.3
