Want this question answered?
You need to remove the grill and then the headlight assemblies. I had to remove the battery as well to get at the last bolt for the headlight assembly. There are about 6 bolts and 4 preasure clips holding the grill on.
Open the hood, remove the two locks that hold the headlight assembly in place, with the two locks removed you can wiggle the headlight assembly out and gain access to the back side of the assembly to remove and replace the headlight bulb.
remove front headlight assembly to get at horn,it is down below light assembly..
It pulls off. Sometimes easier to remove the headlight assembly to change the bulb. We have instructions at our forum. www.trailvoy.com Trailblazer enthusiasts!
Hi, You have to remove the entire headlight assembly to get to the bulb, which is located in the back of the assembly. There are three wing nuts that hold the assembly in, and those will have to be removed. Then remove the side signal assembly first, then the headlight assembly. I have provided a link that shows exactly how this is done and where these wing nuts are. Good Luck
lift up hood, on top of headlight assembly there are 2 tabs to pull up, then pull assembly out...
Remove the headlight assembly above the bad bulb to gain access to the burned out bulb. To remove the headlight assembly, open the hood, locate and remove the two tabs that lock and hold the assembly in place, with those tabs removed you can wiggle the headlight assembly out in the open. Now you can reach in and r & r the burned out signal bulb
Remove the headlight assembly above the faulty signal bulb. This will give you access to the signal bulb socket. To remove the headlight assembly, open the hood, stand in front of the headlight assembly, notice two black tabs sticking up behind the headlight assembly inside the radiator support. Pull up and wiggle the tabs to remove them, this will release the headlight assembly. You can now wiggle the headlight assembly out to gain access to the signal bulb socket for replacement.
Open the hood and notice the two black locking tabs sticking up behind the headlight assembly. Remove those two tabs by pulling on them straight up. This will allow the complete headlight assembly to come out the front. You can now remove the headlight bulbs from the headlight assembly.
Remove the entire head lamp assembly
Stand in front of the headlight in question, with hood open notice two black tabs sticking up behind headlight bucket assembly. Remove the two tabs by lifting straight up. The headlight bucket assembly can now be wiggled out of the car and you can now remove the bulb socket from the assembly to replace the bulb. Reverse order for assembly.
Remove the headlight assembly and you will have access to the parking light bulb.