0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you change the ignition cylinder on a 1991 Cadillac Eldorado?
Remove steering wheel and signal switch
How do you remove the starter from a 1991 Cadillac ElDorado?
get a manual on your car from DISCOUNTAUTOREPAIRMNUALS.COM and it will help on the next repair also.Plus it has pictures.
Is a 1990 Cadillac Eldorado starter compatible with a 1991 Cadillac deville?
Yes
What type of AC coolant does a 1991 Cadillac Eldorado require?
R12
Where is the heater core located on a 1991 Cadillac Seville?
the heater core is up under the dash on the riget side.
How do you reset the service ccr system on the driver information center on a 1991 Cadillac eldorado?
What is needed when the ccr is driver information center
Why does blower motor stay on when the engine is off and the key is removed on a 1991 cadillac deville?
follow the plug from the blower motor. It should lead to another plug on top of your heater core housing.There should be three bolts securing the plug. Remove them and replace the part. I don't know what it is called.My 1988 eldorado did the same thing. Works fine now though.
When was Eldorado Gold created?
Eldorado Gold was created in 1991.
How do you replace heater core on 1991 caviler must you remove dash?
no
Replace a heater core on a 1991 Mazda 626?
# Disconnect the negative battery cable. # Drain the engine coolant. # Remove the instrument panel/dash assembly from the vehicle. # Remove the heater hose(s) and cap the hose(s). # Remove the attaching nuts and remove the heater unit assembly. # Remove the heater core attaching screw and remove the heater core..............
How do you change time on clock on a 1991 Cadillac Eldorado?
you get a pin and push the little hole near the bottom of the right hand side proceed with change the time, date, etc...
How do you replace a 1991 dodge Dakota heater core?
Drain the water from the cooling system. Remove the water hose from the heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
