open your boot and you will see 2 bolts 10mm i think unscrew them and the whole lens comes out watch tho very hard to push out some times they can brake just be careful cant miss the bolts right where the light is at the back cheer
hello mate, it's really simple, pop open the bonnet, then remove the grille and plastic trim connected to it (carefully without snapping the hockey clips), there are three screws, one under the hood on top of the lamp, and two on the bottom left and right. remove these, then disconnect the lamp and height adjustment motors, and remove the lamp. Best Of Luck
Remove the high mount brake light retaining screws from your Mazda Protg. Remove the high mount brake light wiring harness. Reverse the process to install your new high-mount brake light.
Remove the wiring harness from the high mount brake light. Remove the retaining screws. Reverse the process to install the new high mount brake light.
Remove the wiring harness from the high mount brake light. Remove the back cover of the brake light assembly. Take hold of the brake light connector, push in and turn at the same time. Reverse the process to install the new brake light.
Check bulbs?
you need to remove the rear seat
The lens assembly is held in with two screws. Remove those and the lens will pop out.
on the hatch back there is a cover on the door under the light remove it. there are three screws that hold the 3rd light on remove them. unhook the wire harness. remove the small screws from the 3rd light and pull it open. there you can unscrew the light and replace it.
sounds like the brake light switch , about £6 bigish job got to take out the 4 bolts that hold in the steering column , drop the column onto the seat (remove battery lead for 1 hour prior to doing this if you have got an air bag) than the switch is visable , get switch from peugeot because there are 3 types for a 306
The way that you change a high mount brake light on a 2007 Taurus is by first prying the light assembly from the housing. You then push rearward to remove it from the retaining clips. Next, life the light assembly from the shelf and disconnect the assembly wiring. Replace the light assembly and reverse directions to put the light housing back where it goes.
Remove the center piece of trim on the inside of the lift gate. it just pulls off. then push up on the two tabs at the bottom of the light to remove it. then replace bulb with the correct bulb. .....
Stop light. Third brake light, or center high mounted stop light (CHMSL).
if the high mounted brake light is in rear window. open trunk and access the light from below rear window shelf. if the light is in the spoiler, remove the screws holding it in. disconnect elec, connector from inside of trunk lid. the assembly has no replaceable bulbs, and has to be replaced as a unit..