answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you remove the ignition lock cylinder from a 1980 Datsun 210?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How many mpg does a 1980 280z with 4 or 6-cylinder get?

How many mpg does a 1980 Datsun 280Z with 4 or 6 cyl get?


Which was the maximum speed of datsun B210 4-cylinder 75HP 1974?

The maximum speed of the 1974 Datsun B210 4 cylinder 75 HP was eighty miles per hour. This model of Datsun car had a 1288 cc engine and did not perform well during acceleration. Datsun was a popular car during the 1970's and the 1980's.


What gas mileage does a 1980 Datsun 210 get?

38 and 40 hwy 1980 +1/2 Datsun 210 hatchback thank you


How many spark plugs does a 4 cylinder engine have?

4, one for each cylinder. There are also some engines, (for instance, the early 1980's Datsun 2000R, 2200R and 2400Z), that have 2 spark plugs per cylinder.


What is the process for installing a new timing chain for a 1980 Datsun 280zx?

What is the process for installing a new timing chain for a 1980 datsun 280zx?


Where can you find interior pieces for a 1980 720 Datsun truck?

Try LMCTrucks


What is the head bolts torque specs for a 1980 Datsun pickup?

58ft/lb


Where does the wires go when installing alternator on 1980 Datsun 280z?

Red Positive goes to Battery Positive and the small lead goes to the ignition light bulb in the dash which Will be negative until starts charging which will be positive and the light will go out


Where can you find a Throttle Cable for a 1980 Datsun King Cab?

rockauto.com good source


What is the value of a 1980 Datsun 510?

im not sure but id love to buy it off of you :)


Where can you buy a new ehaust manifold for a 1980 Datsun 280zx?

I buy my Datsun 280 ZX parts from Black Dragon Automotive, a Datsun Z car and RX7 specialist company.<p> 800-255-0088 <p>


How do you install a key ignition on a 1980 El Camino?

remove the steering wheel and the turn signal mechanism. Then there is a screw right in front of theignition. Remove the screw and pull out the ignition. Should take no longer than 30 to complete from start to finish.