i would help you but i need more explanation so i can lloooookkk ittt uppppppp.
== ==
howdo you change an ignition switch on a 1996 gmc jimmy howdo you change an ignition switch on a 1996 gmc jimmy
how to remove cover to replace ignition lock cylinder and what type of tools do i need
2005 yukon BACK DOOR CATCH LOCK
were is the rear door relay switch located on a 2003 yukon
if it is the ignition lock cylinder, first disconnect the battery, you need to remove the steering wheel ,turn signal switch , etc, then you need to insert the ignition key into the lock cylinder, turn it to the run position,then pull the cylinder out, reverse the operation to install the cylinder,
How can I take apart the dashboard of a 1995 gmc Yukon
1988 gmc safari Steering column switches and ignition key lock cylinder replacement?
I have a 1999 GMC Yukon Dunoli oil pump went out and Ineed to now what i hafe to remove to get the oilpan out.
how do I remove door lock 99 gmc savana
the module is in the distributor the module is in the distributor. you will have to remove the cap and rotor. it should be held on by 2 screws. good luck
Check the ignition coils and the crank sensor for the Yukon. Either one of these could be bad and cause the problem.