how to remove rear axle from 1988 f250 ford
Normally attached to the distributor (not the cap) on the side. Takes a special tool to remove it. Available at the parts store.
the inline fuse for the ignition requires remove the bezel panel and the gauge panel from dash. trace the red wire up and to the top rear right of the dash you'll find a lump in the wire.
I would look first to the rotor, and then maybe at the module check the ignition module
Short in the circuit, the circuit is overloaded, or you are installing too small a fuse.
You need to specify which module.
They are separate The ignition module is on the drivers side fender usually mounted in the middle of an aluminum box with fins on it. The coil is easy to find just follow the center wire on the distributor and you'll find it.
I'll include a link to a video below that will show you how to repair the ignition coil in your Ford F250 or F350. hope this helps.
What is there stance specifications on an ignition coil for a ford 5.8 f250
don't know about the particular year. on my 95 F250, the ICM is located on the driver's inside fenderwell, underneath the Powertrain Control Module. hope that helps.
The O2 sensor on a 1988 F250 is not near the engine. Go to the exhaust manifold and down the length. It is near the catalytic converter.
what is the timing set's for a 1988 ford F-250