Short in the circuit, the circuit is overloaded, or you are installing too small a fuse.
Normally attached to the distributor (not the cap) on the side. Takes a special tool to remove it. Available at the parts store.
don't know about the particular year. on my 95 F250, the ICM is located on the driver's inside fenderwell, underneath the Powertrain Control Module. hope that helps.
On a 1988 Ford F250, the ignition control module is typically located on the driver's side of the engine compartment, mounted to the inner fender or firewall. It is often found near the distributor and may be secured with bolts. For easier access, you might need to remove some components or covers, depending on the engine configuration. Always refer to a repair manual for specific guidance on your vehicle's setup.
controls all of the electrical systems not related to the motor
I would look first to the rotor, and then maybe at the module check the ignition module
You need to specify which module.
They are separate The ignition module is on the drivers side fender usually mounted in the middle of an aluminum box with fins on it. The coil is easy to find just follow the center wire on the distributor and you'll find it.
I have a erorr code P0603 and P1211 and it said Powertrain Control, Keep alive memory Erorre Can you help me?
driver side valve cover between coolant jug and turbo.
it is located above the heater core trap door behine the glove box.
glow plug control module
the inline fuse for the ignition requires remove the bezel panel and the gauge panel from dash. trace the red wire up and to the top rear right of the dash you'll find a lump in the wire.