I have a erorr code P0603 and P1211 and it said Powertrain Control, Keep alive memory Erorre Can you help me?
glow plug control module
controls all of the electrical systems not related to the motor
Depends on the train; they do not have the same power.
You need to specify which module.
driver side valve cover between coolant jug and turbo.
it is located above the heater core trap door behine the glove box.
Short in the circuit, the circuit is overloaded, or you are installing too small a fuse.
Normally attached to the distributor (not the cap) on the side. Takes a special tool to remove it. Available at the parts store.
don't know about the particular year. on my 95 F250, the ICM is located on the driver's inside fenderwell, underneath the Powertrain Control Module. hope that helps.
On a 1988 Ford F250, the ignition control module is typically located on the driver's side of the engine compartment, mounted to the inner fender or firewall. It is often found near the distributor and may be secured with bolts. For easier access, you might need to remove some components or covers, depending on the engine configuration. Always refer to a repair manual for specific guidance on your vehicle's setup.
Behind your emergency brake release handle
On a 2004 Ford F-250, the Powertrain Control Module (PCM) fuse is located in the fuse box under the hood. Specifically, you will find it in the power distribution box, which is typically situated near the battery. Look for a fuse labeled "PCM" or "ECM" (Engine Control Module) in the diagram on the cover of the fuse box for identification. Always consult your owner's manual for precise details and fuse locations.