the ignition lock cylinder is located on the upper right side of the steering column.the ignition switch is inaccessable unless the steering column is lowered.so the column must be lowered carefully and supported to prevent damage. remove lock cylinder-(note:pull actuating rod for switch up until a solid stop is felt,then push it down one detent to lock position) remove two switch screws and assembly.when replacing switch make sure switch and lock are in lock posistion.
How to remove ignition switch
Remove the retaining ring from the top of your 1989 Chevy Corvette ignition switch. Slide the ignition switch out and remove the wiring harness.
can I switch ignition cylinder with a different ignition cylinder w/key in a 2004 chevy Malibu without having to use a passcode
Remove the retaining ring from the top of your 1999 Chevy Cavalier ignition switch. Slide the ignition switch out and remove the wiring harness from the end of it.
You will need to remove the retaining ring at the top of your 1998 Chevy Lumina ignition switch. Slide the ignition switch out. Remove the wiring harness.
how to remove key stuck in ignition switch in Chevy colbalt
Remove the retaining ring at the top of your 1985 Chevy ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
how do you remove the ignition switch on a 1990 chevy half ton pick-up?
Remove the retaining ring at the top of your 1994 Chevy Corsica ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
The Malibu has been in production on and off for Fifty years, What year are you asking about?
You will need to remove the retaining ring from the top of your 1997 Chevy Camaro ignition switch. The ignition switch will slide out. Remove the wiring harness. Reverse the process to install the new ignition switch.
You will need to remove the ignition switch retaining ring in your 2002 Chevy Astro Van. Slide the ignition switch out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install the new ignition switch.