Carefully pry out the elongated clock on the dash with a flat blade. A butter knife will work. It reveals 2 screws which you take out. Carefully pry out the short plastic air flow direction thingy to the side of the instrument panel wich will reveal 1 screw which you take out. Then there's a screw on the left and right side of the exposed housing of the instrument panel where you would reach thru to touch the instrument pael clear plastic clover and the screws im talking about are on sides. You'll have to use a flashlight to see them as they're not exposed. When these 5 screws are removed, simply use the flat blade to gently ease the panel out.
What would cause the instrument panel on a 1997 ford pickup 150 not to work?
The dashboard lights on a 1997 Eagle Talon can be changed by reaching up into the dash to get to the bulbs. Another way is to remove the dashboard screws and remove the front of the instrument panel.
Pull the ash tray all the way out, then remove the screws from the top of the ashtray slide. Then pull carefully on the the plastic around the instrument panel, There are snap in sockets for the clips on the dash panel.
passenger side behind panel to your left
Access indicator flasher under instrument panel left of steering column. Remove screw retaining indicator flasher to instrument panel. Disconnect connector from indicator flasher and remove indicator flasher from vehical. I am also trying to find flasher on 1997 t bird. I hear it but cant find it- Help please
Remove the battery terminals first. Then the control module is located behind the instrument panel on the left side of the console.
No. To remove the widow its easiest to remove the outside panel
On a 1997 Ford Aerostar : The fuse box is under the instrument panel , on the drivers side
Disconnect the negative battery cable and properly drain the engine cooling system to a level below the heater core.Disconnect the heater hoses from the core tubes near the cowl.The instrument panel must be removed or repositioned for access to the heater core case. Unbolt and either tilt the instrument panel forward or disengage the instrument panel components and remove the panel from the vehicle. In most cases, tilting the panel forward should be sufficient for the necessary access, but if necessary remove the panel refer to in this guide.Unfasten the heater core rear case retaining screws, then remove the rear case for access to the heater core.Loosen the retainers and remove the heater core retaining straps.Remove the heater core and seals.
what steps are required to remove the inside door panel on a 1997 Chevy Malibu.
Fuse 17 (30A) under the instrument panel.
remove the bolts holding on the plastic paneling under the steering wheel in the interior. remove the two bolts connecting the hood release latch from this plastic panel. then remove the panel. the circuit opening relay is under this panel, and is green(in my 1997 tacoma).