on the pass side of the cover there is a small indentationb in the center of the lense. Insert a small screwdriver and pry down gently to release the lense
you have to remove the valve cover , the oil pan and the front timing cover. Then line up all the timing marks and remove the tensioners and guides then remove the cam gears and the chain
There are 2 torx screws you need to remove located on the left/right side of the light. You can only see them with the trunk open. Then remove the light assembly. The sockets twist 1/4 a turn and then remove. Replace the light and reinstall assembly
With tools
97 SL2 does not have a change oil light. Only the red oil indicator which means you have a serious problem
Assuming that you don't have the owners manual, in my 1999 SL2, the DRL relay is in the underhood electrical fuse box which is a rectangular box (maybe 4"x8") to the right of the battery. Unscrew the knob, remove the plastic cover and you'll see a bunch of fuses and relays. The diagram for what is where is molded into the inside of the cover.
the two top ones.
It depends on which solenoid you're talking about. For the fuel pump, horn, AC... remove the cover from the fuse/relay box then the relay just pulls out and is easily replaced.
No
You will probably have to remove fan/pulley first to get clearance then just remove fasteners from rad.
25-35 bucks
On top of the shift housing on the very top of the trans. Has 2 wires into it 7/8 wrench to remove
to reset turn the ignition to the run position open the hood and remove the fuse block cover (beside the battery) there is a red button in with the fuses that says oil reset push and hold the button for 5 seconds. Make sure the change oil light is flashing on the dash then turn key off It's now reset