answersLogoWhite

0


Best Answer

Rocking the steering wheel back and forth a little should free up the key in the ignition, weird quirk that my car had as well.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove the key from the ignition on a 2000 Mazda Millenia?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What other struts will fit 2000 Mazda millenia?

2001 Mazda millenia


Where is the module located on a Mazda millenia 2000 2.5l?

how to change speedometer sensor on mazda millenia 2000 2.3 v6


How many miles per gallon does a 2000 Mazda millenia get?

The Mazda millenia from 2000 gets 20 mpg, 28 on the highway, and 25 on average.


How do you remove a fuel filter from a 2000 Mazda Millenia?

it's in the trunk, under the carpeting, near the back in the centre.


How do you replace a 2000 Mazda millenia alternator?

bottom


How many coils do a 2000 Mazda millenia s have?

a Mazda millenia with a miller cycl engine 2.3 engine has 6 igition coils


Does the 2000 Mazda millenia have a cabin air filter and if so where is it at?

millenia starting with my 2001 had cabin filters. 2000 my and before no hava


What controls the hold light is on your 2000 Mazda millenia s?

Button on the shifter.


What is the air bypass circuit on a 2000 Mazda Millenia s?

air conditioning


Do you have to program the key for a 2000 Mazda?

It depends on what model of Mazda you have. My 2000 Mazda millenia doesn't. It does have reverse teeth though. I would have to go to a dealer to get another one made for it.


How do you replace fuel pump on 2000 Mazda millenia s?

The access panel for the fuel pump is under the carpet in the trunk. Remove the carpet then the access panel.Disconnect the hoses from the pump then remove from the tank.


How do you replace the water pump on a 2000 Mazda Millenia?

In order to remove the water pump on a 2000 Mazda Millennia, you must first remove the timing belt and the pulley for the water pump. Remove the pump itself by detaching the four bolts that are securing it. Next, replace any gaskets, install the new pump, then the pulley, and then the timing belt.