You get a tool that looks like a flattened tuning fork and slide under the bracket to release the spring, then pull the bracket out.
I watched my mechanic try a different method without the above mentioned tool. Use the blade of a very thin feeler gauge. Press the feeler gauge blade between the metal button and the bracket. This also releases the spring. You can then use a screw driver to push out the button.
problem with fuel filterhow do i change the fuel filter on my 2001 Nissan sentra gxe, and where is it located?
Owner's manual.
Doesn't have one.
Are you sure there is one? Ford products typiocally have one, but I am not aware of Nissan having one.
check engine
I changed my fuel pump in my 2001 Nissan Sentra , were n how do you reset fuel pump
in the car near the steering wheel and it's a button, auto start
You can't. It's electronic.. not battery operated.
It is on the passenger side floorboard behind the kick plate( which will be on the right)
2005 Nissan Sentra 1.5 S: Press and hold the Clock button on the radio. When the hour numbers start flashing, *press the UP or DOWN arrows until the correct hour is displayed. Press the CLOCK button again and the minutes will start flashing. Repeat from * to set the minutes. Press the CLOCK button again to exit the clock setup function.
To remove the button bracket for a rearview mirror, start by locating the set screw that holds the bracket in place, usually found at the bottom or side of the bracket. Use an appropriate screwdriver or Allen wrench to loosen and remove the screw. Once the screw is removed, gently slide the bracket off the mounting arm attached to the windshield. Be careful not to damage the glass or the bracket during the process.
There is no vehicle anti-theft system reset button under the dash on a 96 Nissan Sentra. To reset you need to sit in the car and lock the doors with the driver's side door button. Next, insert and remove the key six times quickly and wait for the hazard lights to flash. Once they flash, insert key again and turn to the acc position. Press a button on the remote and wait for the lights to flash again.