The little red part of connecter slides sideways. Then squeeze the top part in and pull up.
Disconnect the electrical connector, remove the mounting screw and remove the sensor.
how to remove and replace transmission fluid pressure switch on a 2002 dodge ram 1500
The oil pressure sensor on a Dodge Caliber is under the intake manifold on the front of the engine.
Oil in the electrical connector end is an indication of a failed sensor.
The 2000 Dodge Ram oxygen sensors are screwed into the exhaust on the passenger side. To remove you unplug the connector and turn counter clockwise with a wrench. Reverse to install.
The map sensor and boost pressure sensor are the same thing.
CRANKSHAFT POSITION SENSOR The crankshaft sensor is located on the passengers side of the transmission housing, above the differential housing Crankshaft Position Sensor The bottom of the sensor sits above the drive plate REMOVAL Disconnect electrical connector from crankshaft position sensor. Remove sensor mounting screw. Remove sensor. INSTALLATION Install sensor and push sensor down until contact is made with the transmission case. While holding the sensor in this position, install and tighten the retaining bolt to 12 N·m (105 in. lbs.) torque. Connect electrical connector to crankshaft position sensor.
The oil pressure sensor is on the oil cooler, under the intake manifold.
it is the oil pressure sensor. Check your oil level, then test your oil pressure sensor.
Dodge doesn't use fuel pressure sensors on any of it's engines.
No such part
where is the transmission fluid pressure sensor located o a 2005 dodge grand caravan