Lift the door handle as though trying to open the door. You should see two pins going through the handle assembly. The pins can be pushed out, allowing you to remove the handle.
You will need to remove the inside door panel of your Mustang. Remove the linkage from the outside door handle. Remove the outside door handle retaining bolts. Reverse the process to install the new outside door handle.
remove the outside handle by lifting the handle up and removing the small clip in the underside of the handle The inside door handle? remove the screw pull towards the front then out and release the clips holding the lock and open rods
You will need to remove the inside door panel. Remove the door handle retaining screws. Remove the linkage from the back of the door handle.
First, it's a little backward. The S-series Saturn's did not have inside door panels that could be removed. You need to remove the OUTSIDE door skin.First, remove the outside handle, there are two pins that you can press through the handle. Just lift up on the handle part way and the pins will be exposed. Press them through using something round with a flat end.After you've done that, open the door all the way and look around the perimeter. There are several screws that hold the outside door skin in place. Remove the screws and the door skin should lift right off.
I don't know - but the question about the 1993 door handle is the same...
* To remove the outside door handle and lock assembly raise the window and remove the door trim panel and watershield * Working through the access hole disengage the plastic clips that secure the outside handle to latch actuating rod and the outside door lock to latch actuating rod * Working through the access hole remove the outside door handle retaining bolts * Remove the handle/lock cylinder assembly from the car
Remove the inside door panel of your 1994 Chevy Lumina. Remove the door handle linkage. Remove the door handle retaining bolts. Reverse the process to install the new door handle.
take inside door panel off and unbolt outside door handle from the inside.
* To remove the outside door handle and lock assembly raise the window and remove the door trim panel and watershield * Working through the access hole disengage the plastic clips that secure the outside handle to latch actuating rod and the outside door lock to latch actuating rod * Working through the access hole remove the outside door handle retaining bolts * Remove the handle/lock cylinder assembly from the car
To remove the outer door handle on a 2008 Saturn Aura, first, ensure the door is open and locate the screws securing the handle, typically found in the door panel. Use a screwdriver to remove these screws, then carefully pry off the door panel to access the handle mechanism. Disconnect any linkage attached to the handle, and finally, slide the handle out of its housing. Reassemble in reverse order after replacing or repairing as needed.
If it's the outer handle you would need to remove the door panel, then remove the rivits that hold the handle to the outside of the car. Then remove the window track and slide it down inside of the door and unhook the rod on the handle,and now you can slide the door handle out.
you have to remove the lock clinder