Never worked on this specific model, but it should be identical to the T660. There's three screws on the bottom, two in the middle, and two on the top.. aside from the front bottom screw, they're all concealed by covers you'll need to pop out with a slotted screwdriver, then you take the screws out with a Phillips screwdriver. If you have the manual window, you'll need to pop the center cover out of the handle, unscrew the screw with a Phillips screwdriver, and pull the handle off.
Once that's done, you pull back on the top to unseat the hooks, push up on the panel to unseat the remaining hook, then pull it out... before you pull it out completely, you'll need to disconnect the weatherpack terminals for the door lamp, power door locks, and power window (if applicable). The door seats around the small window at the bottom by the seal around it... just pull the panel out, and the window components all remain in place. Then there's a black panel covering all the components... I'd recommend marking the holes for all screws in that with a marker or paint pen before removing them. To get that one off, you'll need to unscrew the mounts for the actuator, and the power window, as well... those screws are silver, rather than black.
Depends on the make/model/year
Roll the glass down because the glass comes out with the panel.
Under the hood, against the firewall, on the passenger side of the vehicle. It's encased in the HVAC compartment, and there's a metal panel you need to remove to access it.
Most models of Kenworth have it in the kick panel on the driver's side.
Remove the glove compartment, and it'll expose the primary fuse and relay panel.
Either in the fuse panel to the left of the clutch, or behind the dash on the passenger side.
Using a screwdriver, remove the screws from the panel, remove the clips from the panel, and pull the panel away gently. Remove any wiring connectors, and remove the panel from the frame.
Using a screwdriver, remove the screws and clips from the panel. Pull the panel away slowly, remove wiring connections and the panel will come free.Ê
The 2000 Chevrolet Blazer passenger side kick panel is held in place by eight retaining bolts. Remove the retaining bolts and the kick panel will come free.
Type your answer here... how do you remove passenger door panel on 2001 mercury marquis to replace door lock.,
remove door panel then remove screws behind mirror. remove door panel then remove screws behind mirror.
toyota avensis 2004 how to remove door panel from passanger side front door