answersLogoWhite

0


Best Answer

On the left side of the bike, underneath the seat, above the exhaust, there's a place you can stick your key in. Simply twist and the seat should pop off.

Check your owner's manual for pictures.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove the passenger seat on a 2004 suzuki aerio sx?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the bolt pattern on a 2004 suzuki aerio?

4x100


Is there an engine diagram for a 2004 Suzuki Aerio?

alldata.com


How do you remove alternator from suszki aerio 2004?

The alternator on a 2004 Suzuki Aerio can be removed by first loosening the retaining bolts and taking off the drive belt. The alternator is then fully unbolted and pulled from the engine.


What happens when your camshaft goes out on your 2004 suzuki aerio?

your engine is wrecked


How much oil does 2004 Suzuki Aerio take?

5 quarts


2004 Suzuki Aerio car shakes when you start it and also when at idle?

get a room stop phucking in it


What could be causing 2004 Suzuki Aerio to Overheat?

Probably would be in your best interest to check the head gaskets.


Where is the fuel filter on a 2004 suzuki aerio?

SUZUKI Aerio electric fuel filter and pumps are almost always located inside the fuel tank, and recommended a replacement after 240.000km. the advantage of this filter is require no maintenance as long there is no problems with the engine performance.


When should a timing belt on a 2004 Suzuki Aerio be changed?

its a chain not a belt.... True. So unless it breaks, you don't have to change it.


How do you remove rear brake drum on a 2004 suzuki XL-7?

how do you remove rear brake drum on a suzuki 2004 xl7


How do you remove the dash from a 2004 Suzuki Vitara 4x4?

How do I remove the dash on a 2004 Suzuki Grand Vitara 4wd to get to the radio wires?


How do you remove front rotors from 2004 suzuki aerio sx?

1. jack car and remove wheel 2. remove the brake caliper and pads by removing the two bolts holding on the caliper 3. remove the mounting bracket for the brake caliper by removing the two bolts attaching it to the spindle. 4. pull the rotor off