You do not need to completely remove the door panel, just loosen it enough to remove the triangular cover.
First, remove the screw from the inside bottom of the armrest. Next remove the small cap covering the screw inside the door opener molding and remove that screw. Now, remove the screw on the upper edge of the door panel close to the car frame. This will allow you to gently pull the panel away from the door about an inch.
Use a small screw driver to pop off the triangular cover. There are two snap fittings. Now, carefully undo the bolts holding the mirror assembly to the door. Be careful not to drop the nuts or your sockets into the door cavity!
If the mirror is powered, squeeze the wiring harness connection and unsnap it. The mirror should now be free.
Remove the inside door panel of your 1993 Chevrolet Lumina. Remove the passenger mirror wiring harness. Remove the passenger mirror retaining bolts. Reverse the process to install the new passenger mirror.
Chevrolet Lumina. Remove the wiring harness or the mirror linkage. Remove the mirror retaining bolts. Reverse the process to install the new passenger side mirror.
remove the plastic panel and there are 3 ten mm nuts remove and replace mirror.
To replace the passenger side mirror on a Chrysler Voyager you need to first remove the window trim. Next, disconnect the wires and unscrew the mirror from the door. Reverse directions to replace with new mirror.
The passenger side mirror on a 2001 Toyota Sienna is mounted by screws. To replace the mirror remove the mounting screws and unplug the wire clip.
# Remove the door trim panel and watershield.Disconnect the electrical connector from the mirror # Remove the retaining nuts and detach the mirror from vehicle
* Remove the mirror trim cover from the door panel * Remove the three mirror retaining nuts and detach the mirror from the car
You have to remove door panel
Go to this website. It will show how to remove the door panel and the side mirror.
Remove the door panel and the mirror is held on with bolts.
you have to remove door panel and there are three nuts you have to take off of the mirror.
on top of door panel behind the mirror. remove the plastic cover by prying it off. remove the mirror nuts, and then remove mirror. if it has mirror adjustment cables on it. just remove these cables, and put on with new mirror if needed.