0
What else can I help you with?
How can you remove the left spark plug on a 2001 Chevy s-10 v-6 engine when it is blocked by the steering column?
Move the steering shaft. There is one bolt under the plastic cover. This is the pinch bolt .Remove it and slide shaft towards firewall ,move shaft out of the way ,replace plug,re-install shaft,bolt and plastic cover.
Why do people pinch?
Some people pinch to vent their frustration. This is normally the case in young children as they might pinch or hit to express anger.
How do you remove salt that has hardened in the grinder?
Not to sure how to remove it but to prevent it add a pinch of dried rice in it
How do you remove a 1980 Porsche 911SC fuel pump?
disconnect the neg batt terminal. raise the car in the front and support on jack stands. remove the metal cover under the fuel tank. pinch off the fuel lines leading to the pump. remove the two leads + and -. unclamp the pump.
Where do you put a tire jack on a 2007 Chevy Cobalt?
Under control arm or pinch weld
Where are the jack points on a 1999 Chevy Cavalier?
the pinch welds are the best place to life the car
How do you remove the hydraulic fitting on the transmission of a 1999 Chevy S-10 with the manual VN1500?
You need to pinch the plastic sleeve and push from both sides 180 degrees. In then releases the entire connector and plastic hose. (black)
How do you change the headlight just the bulb of the Cadillac Catera 2001 without removing the battery you could not see the ring around the bulb and don't know how to remove it?
It can be done by touch but the risk to damage the headlight assembly (ass'y) is high. To take out the ass'y is done by removing the grille (4 screws) then the molding under the ass'y (no tools) then 2 screws under the ass'y. To replace the bulb by touch, remove the cover above the headlight (looks like a part of the shroud). Remove the black plastic cover. Pinch and remove the wire harness, pinch and remove the bulb holder. The bulb holder has a wire retainer similar to a paper clip and can pop out of position easily. Pinch and remove operations can break a plastic hinge that's necessary for headlight aiming (that's the risk). It seems like a lot of trouble to take out the whole ass'y but its really one of the easiest things you can do on a Catera. Start to finish it will be about 30 minutes for each light.
How to replace low beam in 2003 e 320?
Remove light protective cover by twisting counter clockwise Remove light bulb by twisting connector counter clockwise Pinch metal clips and remove wiring harness do not touch new bulb with fingers reinsert in housing connect wiring harness reverse above steps to complete process
How do you replace Hyundai tiburon licence plate light bulb?
were your plates are at if you look under were the caps that shield the light bulbs there should be like two tabs that you sort of pinch together and then pull down were the shield caps should remove entirely and then unplug old bulbs and plug the new ones in and again pinch two tabs together when you cover bulbs again
What part of speech is pinch?
To pinch is a verb. "Pinch" as in the phrase "in a pinch" or as in "a pinch of salt", then pinch would be a noun.
How do you get a duvet cover on a duvet?
The easiest way to get a duvet inside the cover is the following... Turn the duvet cover inside out....then put your arms inside and pinch the bottom corners with your fingers...then pick up the corners of the duvet or comforter and pinch all the corners together with your fingers.... pull the corners inside the duvet cover by pulling the duvet at the same time you are flipping the duvet cover over your arms and over the duvet!! You will have to tuck in the top corners of the duvet inside the duvet cover at the top...then button it up and you are done!
