I need to pull the springs back to eliminate the lombar
The Chevrolet equinox front speakers are held in place with two retaining screws. Remove the retaining screws and the wiring harness. The speakers will come out.
if you face the front of the car with hood up, its under plastic to the front right. (front being near the bumper, not upward) ontop of the plastic are 3 electric plugs, you don't need to remove them just unscrew the 3 screws and remove. its kind of a pain really.
This is an extremely big job to remove the Heater A/C case on Chevrolet Equinox and Pontiac Torrent when there is a problem with no heat or can/t adjust temperature. ----------
Remove the 2 round plastic covers over the screws,remove the screws and pull to the outside of the vehicle.
It is on the passenger side behind the starter. You must remove the starter and bellhousing cover (black plastic piece behind starter). The sensor is behind and above the starter, held in by one bolt and a bracket.
Remove the door bezel.Remove the window switch.Remove the door pull trim bezel.Remove the 2 7MM bolts behind the door pull trim bezel.Using a door panel tool, you should be able to remove the plastic clips behind the door panel.
on top of door panel behind the mirror. remove the plastic cover by prying it off. remove the mirror nuts, and then remove mirror. if it has mirror adjustment cables on it. just remove these cables, and put on with new mirror if needed.
You must remove the plastic panels that cover the back of the taillight from the inside of the truck. Check for the scews behind the caps then pull the rest of it off.
how yo remove battery from 2012 equinox
It is on the driver side near the radiator. It is in a black box. The top of the box (lid) has s)the computer fastened to it. You have 4 plastic fasteners (clips) to move and the Brain comes off. You can leave the wires connected and lay it to the side. There or bolts that hold the lid. remove those, remove lid and there is your battery....
yes, it is,,, just pop out. you need remove the hard plastics clips.
on top of the engine. its in a container with a top that requires either a 1 1/4 socket or a pip wrench to remove.