Want this question answered?
With utmost care :)
Disconnect negative battery cableRemove the dash center bezelRemove the radio retaining bolts and pull the assembly out of the instrument panel,disconnect the antenna and electrical connectors and remove the unit from the truckHow do you remove the center bezel?
In order to remove the radio unit, you need to unbolt the radio. The bolts are concealed by the dashboard's trim panels.
The radio on a 2003 Chevy Impala can be typically be fixed by replacing the fuse. If the radio does not work when powered, it will need to be replaced with a new unit.
The radio unit on a Hyundai Elantra is held in place by a mounting bracket found behind the center console. First remove the center console then remove the screws on the mounting bracket. The radio will be able to slide forward. Once pulled out remove the wire harness that plugs into the radio.
Under the drivers seat.
Check the Electronic Control Unit. I also had the same problem and it was the Unit( Computer box)
You can remove the radio unit from your 1997 Nova with a flat head screwdriver and a Phillips head screwdriver. You will not need any other tools to complete the task.
1. Open the ash tray and remove the felt lined insert, behind it is a bolt you need to remove. 2. With that bolt removed you can pop out the ash tray/climate control unit, and you will be able to see the two bottom bolts for the radio. 3. Above the radio you will need to pop out the ac vent, it isn't screwed in so you just have to pull on it and it will pop out. With the vent removed you will see the top two bolts for the radio. 4. Remove the 4 bolts and the radio will slide out.
First remove the outer casing the thin black plastic strip around the outside of the radio, you do this by pushing in 2 plastic hooks at the top and bottom. now look below the radio on the dash you will find 2 philipshead screws holding the plastic casing around the radio. remove these and also the plastic casing. on the underside of the radio is a metal dock with screws on either side of the unit. remove these 4 screws and slide the the unit forward remove the plug in the back of the unit. discard radio and plug in the new CD player repeat the steps above in reverse.
# Remove the center trim panel # Remove the radio mounting screws then pull the radio out of the instrument panel just far enough to access the electrical connectors and the antenna cable on the back of the unit # Disconnect the electrical connectors and the antenna lead from the backside of the radio and remove the radio
# Remove the center trim panel # Remove the radio mounting screws then pull the radio out of the instrument panel just far enough to access the electrical connectors and the antenna cable on the backside of the unit # Disconnect the electrical connectors and antenna lead from the backside of the radio and remove the radio