0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you remove rear bumper on a 2002 Elantra?
1. If needed raise vehicle and support it on Jack stands 2. Remove the retaining screws in the wheel wells and along the upper and lower edges of the bumper cover. Remove the tail light housings. Remove the rear trim plate and pull luggage compartment trim out for access then remove the remaining bumper cover retaining screws. Remove the bumper bolts 3. On station wagons remove the rear window washer fluid reservoir for access to the bumper retaining bolts. The remaining bumper bolts are accessible from below 4. Pull the bumper and cover assembly out and away from the car
How to remove rear bumper from a MCI bus?
There are only 2 bolts holding it on, take them out with a 3/4 wrench and wiggle the bumper off.
How do you take out front bumper grill on Mazda 3 sport?
Usually to remove the front bumper grill you would just locate the screws or bolts holding the part in place and then remove them. The grill should be able to be removed after that.
How do you remove the rear bumper on a 2002 Honda Accord?
There is a site that shows how to remove the rear bumper in an Accord but it is NOT the 2002 but the 2003 model. I don't know how much different this would be but it might give soe insight. The link is www.cardomain.com/ride/650229/3
How do you remove the rear bumper from a Toyota Corolla?
For 2005 Corolla (may fit Corolla 2001 - 2005)Tools reruired:1/ 4 mm slot screwdriver2/ #1 Philip hear screwdriver3/ 10 mm socket and 1/4" drive4/ 10 mm deep socket5/ 6" 1/4" drive extension.Procedures:1/ Remove spare wheel cover assembly2/ Remove rear floor finish plate by:a/ remove the 3 clipsb/ use a screwdriver to pry out the rear floor finish plate carefully.3/ Remove the luggage compartment trim cover inner LH by remove 4 clips.4/ use same manner to remove the luggage compartment trim cover RH.5/ Disconnect the rear bumper side seal LH.6/ Disconnect the rear bumper side seal RH.7/ Remove the rear bumper cover by removinga/ 4 nuts with 10 mm deep socketb/ 2 screws inside the bumper coverc/ 6 clips at the bottom of the bumper coverd/ Disengaged the hooks and remove.
What is the cost of repairing a brand new 07 Mazda 3 front bumper and headlight?
I just had to repair the front bumper and headlight of my 08 Mazda 3 and the total cost was around $1600 at the dealership through my insurance.
How do you remove Mazda 3 headlight unit?
To remove the headlight on the mx-3 you must unbolt the front bumper, loosen all 4? bolts and disconnect the headlight wiring. The whole unit should just pull right off.
How to change rear tire of Mazda 3?
how to remove a tire on 04 mazda3 bolts are off and tire wont come off
Is Mazda 3 front wheel or rear wheel?
The Mazda 3 is front wheel drive.
How do you remove Mazda mx 3 headlight unit?
To remove the headlight on the mx-3 you must unbolt the front bumper, loosen all 4? bolts and disconnect the headlight wiring. The whole unit should just pull right off.
How do you remove a 97 Honda Civic rear bumper cover?
Find all the clips, then pull them off. There should be 2 or 3 screws on each side.
Can a 2007 Mazda 3 front bumper fit a 2006 Mazda 3 model?
yes it does... however, the bumper must match the car. what i mean by that is, the sedan bumper will not fit the hatch. and vice versa. the clips are the same. the outer shell is shaped a little different. eg. the back bumper has a finger groove to make it easier to open the trunk. subtle differences like that.
