If the caliper is locked, you will need to disconnect the brake line to remove the line pressure. Then disconnect the e-brake cable, then the caliper. If it is still stuck, you will need to retract the piston inside the caliper - sometimes they stick and you have to lube the caliper and hit the caliper with a hammer lightly or it can crack. Another way is to CAREFULLY heat the caliper with a torch until the caliper expands and releases. If any question please e-mail me Ben. thejamesclan5@msn.com good luck!
Don't try to re-use a caliper that has locked. While you may be able to free it temporarily, they almost always end up sticking again. The cost of a loaded new or remanufactured caliper assembly is cheap insurance against it sticking any time in the near future.
remove and replace water pump in 1997 Oldsmobile aurora
6
you cant! impossible.
under the intake manifold you have to remove the engine cover to get to it.
Remove the intake manifold. The starter is underneath.
If it is locked up then replace that caliber and remove and replace all brake fluid in the system.
It's under the intake manifold. Remove that & the starter is accessible.
pull front of rear seat up. remove it and battery is right there
The 1995 Oldsmobile Aurora 4.0 liter engine crank sensor is located on the back of the crank. You will need to remove the rear engine cover in order to view the crank sensor.
BRING SOME TOOLS TO THE JUNK YARD--GO PRACTICE.......
The easiest way to disarm your Oldsmobile alarm system is to remove the fuse. The alarm fuse location is listed on the inside cover of the fuse box.
It is very easy to change the license plate light on an Oldsmobile Aurora. All you need to do is remove the license plate and look above where the plate was. There are bolts that are holding the light in. Unscrew the bolts and then replace the light.