Want this question answered?
How do you remove the interior rear door panel on a 2004 isuzu ascender?
hammer and sledge
It's located on the inside of the fuse door panel.
Door PanelsRemoval & Installation1. Remove the sail panel (Front Doors Only). (Triangle looking shape near the side view mirror)2. Remove the door panel by carefully lifting the panel upward to release the retaining clips.3. Remove the electrical plugs that control the windows, exc.The installation is the reverse of the removal.
If the inside of a 95 is the same as a 97 the plastic grill on the door panel covering the speaker should pop off using a flat end screw driver. If theres not then you'll have to remove the door panel, which isn't hard. It can be done in about 5 minutes.
there is small swcrew covers that cover the screws across the bottom and inside the handle there is two screws that need to be removed then carefully pull up on the door and it should come off then unhook the door swithes and there u go
First, pop off the switch panel, carefully with a screwdriver. Use a screwdriver to remove the triangular trim near the side mirror. Unscrew the single screw under the door handle. Pop off the speaker grill and remove the 3 screws surrounding the speaker enclosure. These would be the outer ones, not the ones directly holding the speaker in place. Lastly, pop off the arm rest handle with a screwdriver, revealing two final screws to remove. Go around the perimeter of the door panel with a screwdriver or your fingers to pop the clips, which in turn loosens the panel. Lift up to unhook the entire door panel from the door and pull off gently. Note that there will be several wires that will still link the door panel to the door. You will need to find a way to support the door panel with something, or find a way to disconnect the wiring to fully remove the door panel.
You can get a diagram for the driver door lock mechanism for a 2001 Isuzu Rodeo at various auto part stores. You can also check in the owner's manual.
under the driver's door to your right.
Check the servo in the door panel.
Open the drivers door and it's right there on the side of the dash. There's and box in the engine compartment also for most of the engine relays and fuses.
First, pop off the switch panel, carefully with a screwdriver. Use a screwdriver to remove the triangular trim near the side mirror. Unscrew the single screw under the handle. Pop off the speaker grill and remove the 3 screws surrounding the speaker enclosure. Lastly, pop off the arm rest handle which reveals two final screws. go around the perimeter of the door panel with a screwdriver to pop the clips, which in turn loosens the panel. Lift up and pull off gently.