answersLogoWhite
Oldsmobile Cutlass Supreme

How do you remove the rear seat in a 1986 Oldsmobile Cutlass Supreme?

464748

Top Answer

User Avatar
Wiki User
2015-07-15 20:04:25
2015-07-15 20:04:25

Push on bottom of seat front side from floor towards trunk (takes some effort) until unit unclips from locks -- then lift out

You may try to lift from back of lower seat cushion first and then slide to unclip, but I've had better luck the first way

1

Related Questions

User Avatar

My 1986 cutlass supreme w/307 was smoking bad, and I tore the motor down and the rings were shot.

User Avatar

what type of refrigerant does a 1986 oldsmobile cuttlas suprem air conditioner require? reply to: jwilbertr@gmail.com

User Avatar

it the handle on the side of steering wheel chick it towards you or oppsite

User Avatar

It isn't an easy job as you have to remove the inner finder panel.

User Avatar

more than likely you have a blown fuse in the fusebox for the power windows.

User Avatar

what is the ratio of gears in a 1986 cutlass

User Avatar

There are 2 bolts that hold the starter in place and 2 nuts that hold the wiring to the solenoid.

User Avatar

Most likely either a bad float in the fuel tank or defective gauge

User Avatar

My 1986 Olds Cutlass Calais doesn't have a serpentine belt. It has a separate alternator belt. How do I change it?

User Avatar

With the key, there is no trunk release inside the car. You use the same key you would use to open the door to open the trunk.

User Avatar

I dont think there is a fuse for it. My speedometer stopped working in my cutty too. Its a cord that they have to replace. Take it to a shop, they'll tell you.

User Avatar

1981-1987 regal, also possible Monte Carlo & grand prix (same years).

User Avatar

Behind the kick panel on the passenger side of the car.

User Avatar

Either a 231 cid V6 or a 307 cid V8

User Avatar

Answerif v6 2.8I have the 307ci 5.0L V8 in mine...and it's stock.

User Avatar

it is located behind the power steering pump on the engine block

User Avatar

Replace ignition module (under the distributor cap)

User Avatar

open the fuse box and there should b a diagram on the underside of the lid.

User Avatar

In the Cutlass Supreme, 3.8L 231 ci V6 or the 5.0L 307 ci V8

User Avatar

I found the easiest way to do remove the woodgrain faceplate is to take a small scewdriver, and bend the end of it until it is hooked shaped, then put the hook behind the faceplate one corner at a time, slowly pulling out until each corner pops loose. Its the best way I know how, I have took many off this way with no damage to the faceplate.

User Avatar

May have to remove rear seats and get in from there

User Avatar

If the lock cylinder is worn out....sure.

User Avatar

The fuse is in the fusebox but unless it's labled I couldn't tell you which one it is, just start checking all the fuses to make sure there all good unless you still have your owners manual and it will tell you in there.

User Avatar

A 1986 Olds Cutlass supreme can be a V8. It has to motors that year. a v6-3.8L CARB or a v8-5.0L CARB. So yes it can be a V8 in that year. If you dont know just look on how many spark plugs there are, if you have 6 its a V6. if you have 8 you have a V8.. It can be a diesel also....


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.